Dental Handpiece Repair is a Lot of Work

16.10.2012 | Author: hujluni | Posted in Accounting, Accounting Payroll, ATV, Automotive, Business, Mobile Audio Video, Motorcycles, RV, Trucks

Dental Handpiece Repair is a Lot of Work

You may need to keep in mind that you should tidy your dental equipment handpiece before autoclaving to remove any organic material that might corrode your handpiece. Also don’t forget the fiber optics as organic & other material can attach to the lens in the work of autoclaving & reduce function. A soft bristle brush & warm water is all you need. It is not advised to make use of detergents or soaps as they can destroy the optics. Soap can also get in to the bearings & weaken the lubrication reducing the life of your dental handpiece.
Here are three symptoms that your dental handpiece isn’t working properly.

1. Excessive vibrations – If you use a dental handpiece and it begins to vibrate more than you consider normal, this could be an indication that the bearings within are loose. If this is the case, they’ll need to be replaced by a dental handpiece repair specialist. Alternatively, the problem could be caused by a lack of lubrication and, if so, you should flush the handpiece with oil as directed by the manufacturer.

2. Reduced revolution speed – Over time, you may find that your ultrasonic cleaner handpiece’s rotation speed decreases significantly. This is most probably caused by a fault with the turbine inside, or several other potential issues, and you will need to get this addressed if you’re to continue carrying out successful treatments on your patients.

3. Disturbed rhythm – If your handpiece makes clunking noises and rotates irregularly, this could be because of a motor or turbine problem. This is often caused by old age or a lack of regular servicing, and you will need to get your motor or turbine replaced to ensure consistently smooth revolutions that don’t pose such a risk to the teeth and gums of your patients.

For repair, many methods have been tried over Teeth Whitening the years to avoid this costly part of dental handpiece maintenance. There are numerous repair shops that do a good service but are more expensive than “Do It Yourself” methods. But, do it yourself takes time and often does not work out for a large practice. Consider the following process:

Step 1: Remove the back cap and take out the turbine from the slot in the head.

Step 2: Remove the “O” rings and clean them, as well as the head and cap. Check if there are washers in the handpiece; if there are, clean them too.

Step 3: Make sure to put back every component into the right place. A handpiece will not function correctly if any of its components are not placed correctly.

Step 4: Lubricate the bearings, Water Filter before you put everything back together. There is a special bearing oil that you can use for this. Before you lubricate, however, check if your handpiece requires lubrication because there are some bearings that do not need to be lubricated; an example of which are the ceramic bearings.

Step 5: Sometimes, your handpiece will require more than just cleaning and you will be replacing your bearings with new ones. Ask your service provider to know which type of bearings to use.

Step 6: After putting back all the components, make sure to seal the cap tightly and then run the handpiece. It should be running like new.

That’s a lot of work at the end of the day for anyone in the office. A better alternative is to purchase handpieces from a dealer who provides service from the same manufacturer.

This article is from http://www.zeta-dental.com.au/article-628-Dental-Handpiece-Repair-is-a-Lot-of-Work.html

http://www.zeta-dental.com.au/category-1932-b0-Marathon-Micro-Motor.html

Looking for more dental equipment australia at www.zeta-dental.com.au

Short Articleswww.short-articles.net

Dental Handpiece Repair is a Lot of Work

Related dental articles address

Leave a Reply

Additional Articles From "Accounting"

Authorization